Unix, Linux, DevOps , Cloud computing and BigData Knowledge-Base

1

Storage : Verifying STMS (mpxio) Health

The steps below will help confirm that STMS is being used and both paths are seen. 1. Validate that STMS is enabled: Check that the mpxio-disable parameter is set to “no”. *Solaris[TM] 7,8,9 — check /kernel/drv/scsi_vhci.conf *Solaris[TM] 10 only — /kernel/drv/fp.conf Example: mpxio-disable=”no”; If mpxio-disable is...

2

IPMPSolaris Troubleshooting : Link-based Only – Failure Detection with Solaris 10

This document is a short summary of failure detection types with additional/typical/recommended configuration examples using Link-based failure detection only. Even though link-based failure detection was supported before Solaris 10 (since DLPI link up/down notifications are supported by used network driver), it is now possible to use...

2

Solaris Troubleshooting : netstat -a reports connections in the BOUND state

The BOUND state is the state a socket shows after it is created and the ‘bind()’ call is made, but none of the ‘listen()’, ‘accept()’, ‘connect()’ or ‘close()’ calls have been made.  The confusion is that it is not a TCP state, it is a socket...

 
Close
  Our next learning article is ready, subscribe it in your email

What is your Learning Goal for Next Six Months ? Talk to us